1936 Curtis inspired TearDrop Trailer

<-BACK previous next
thumbnail
Craig & Louise talk about the telescoping hitch
thumbnail
Jig welded frame is .090 square tube 2". The tongue is heavier.
thumbnail
thumbnail
This is a 3500 lb rated axle with electric brakes.
thumbnail
Tongue at full extension. The idea is that the tongue can easily be taken off when stored, or fully extended for additional leverage if I need to disconnect it from the Jeep & turn it around by hand in a tight spot.
thumbnail
Galley Kitchen cabinets. Note Sliding workspace at right side. Sliders are rated for 100#.
thumbnail
The woodgrain on the cabinet doors is matched up
thumbnail
See the shelf?!
thumbnail
Sides all cut out. That's 1" thick plywood, so go ahead & lean on it!
thumbnail
Gluing the floor and aluminum together.
thumbnail
The bottom of the trailer is covered with .040 aluminum.
thumbnail
This is the floor, but upside-down. We also wanted tow points at all 4 corners. I'm sure we'll use them sooner or later.
thumbnail
Added "slider bars" to help keep this thing from getting stuck on the rocks. And protect the floor.
thumbnail
thumbnail
Galley counter ready to be installed.
<-BACK previous next